Annotaions not starting at correct timing.

Jun 04, 2012

I am adding an arrow a few seconds after a transition to a new graphic, but when I preview or publish the project, the anotaions show MUCH earlier than recorded.  Any ideas?

Thank You

-Tim

3 Replies
Tim Hickman

Yes.  Thank you.  I used a wipe to reveal a list & then added annotations in sync with the VO, however when previewed or published, the annotation displayed MUCH earlier that created.  I changed the wipe to a fade & the issue resolved itself.  I'm not sure what happened but will let you know if I run into the issue again.

This discussion is closed. You can start a new discussion or contact Articulate Support.