I recently upgraded to Studio 13. When publishing some training modules, I get an error. I don't know if my modules are too big or what. I don't recall publshing anything this big before. One module has 250 slides. So I thought I would try a smaller one which is 79 slides and I get an error with it as well. Any thoughts?
As a test, I published an 18 slide presentation which is about the normal size I usually publish. It worked fine. Is there a size limit on publishing? If so, is there a way around it to be able to publish sucessfully?
There is not a size limit on publishing, but it may be about where you're publishing and how. Can you confirm you're following along with these guidelines in terms of publishing to a local drive and adhering to the file path information. If the behavior persists, I'd also look at conducting the repair here.
4 Replies
As a test, I published an 18 slide presentation which is about the normal size I usually publish. It worked fine. Is there a size limit on publishing? If so, is there a way around it to be able to publish sucessfully?
Hi Doris,
There is not a size limit on publishing, but it may be about where you're publishing and how. Can you confirm you're following along with these guidelines in terms of publishing to a local drive and adhering to the file path information. If the behavior persists, I'd also look at conducting the repair here.
Thank you Ashley. That was the issue. I had it saved on a network location. Once I moved it to my local drive it published fine. Thank you again.
Awesome - thanks for the update Doris.
This discussion is closed. You can start a new discussion or contact Articulate Support.