I created slide that contains several layers. Each layer includes a trigger that turns on the layer above it. The upper layer includes a trigger that turns off the layer below. Thus, all layers show up one after the other, from bottom to top.
The problem is that there is a second delay between each layer (transition is set to "none").
3 Replies
Hi Amit
you should check the delay caused by the animation(if any) on the object on side layers.
share your story file if you can, so that we can have a close look.
Good luck !
That was it.. (rookie mistake..)
Thank you very much! :)
You are welcome !
This discussion is closed. You can start a new discussion or contact Articulate Support.