add trigger witj motion path

Dec 24, 2021

Hanaë SAID
By Hanaë SAID

Hi guys

I added a "motion math" trigger on some images.
Simple idea :

- when cursor overlays an image, the image has to move upwards.
- then, when cursor moves out of the image, image shoul go back to its initial position.

 

However, I encountered TWO issues :

1) When my cursor overlays the image : image seems to go down before going up (it's ONLY suppose to go up)

2) when cursor goes out of the image : again, the image move a little down before going back to its initial position

I can share my project if you want to have a look :)


Thank you very much !!

 

6 Replies
Walt Hamilton
over 2 years ago12/28/21 at 3:22 am (UTC)

It sounds like the beginning points of the two motion paths are not accurately set.  You can adjust them using the X and Y values in the ribbon. Go to Animation, and select the relevant motion path, and its X, Y, and length values show on the ribbon. If it has a width value, that means it is not moving straight up and down. Also be sure the start position is set to relative.

Hanaë SAID
over 2 years ago12/29/21 at 9:34 am (UTC)

I adjusted them so that the starting point is located in the barycenter of my pictures.
When I click on "relative" position, I don't get the effect I want : the picture goes up when I slide my cursor on it and it doesn't go down afterwards (it continues to go upward everytime I fly over it....

Sign In to Reply