Has anyone run into this...I have a png of a gear that I applied the spin feature to. The gear turned in a clockwise motion in the same place, like you would expect a gear to move. I then added another gear and set it exactly the same and that gear does not spin in a circle in place, the whole png moves in a circle. I checked the settings for both and they are exactly alike...but move differently. Help!
That seems odd. By any chance did you apply a circular motion path to the second gear, rather than a spin animation? You can always share your .story file here and someone will have a look.
No, I did not apply a motion path at all...ugh! Thanks for the suggestion though Michael. I am going to ask a few more co-workers to take a look at my file, and if we can't figure it out, I will post my .story file here.
2 Replies
That seems odd. By any chance did you apply a circular motion path to the second gear, rather than a spin animation? You can always share your .story file here and someone will have a look.
No, I did not apply a motion path at all...ugh! Thanks for the suggestion though Michael. I am going to ask a few more co-workers to take a look at my file, and if we can't figure it out, I will post my .story file here.
Thanks!
This discussion is closed. You can start a new discussion or contact Articulate Support.