Confused on seekbar and trigger

Jun 18, 2020

Hello, I am very new to Storyline.  I am working on my first eLearning module for my Masters program and am not sure how to fix a trigger problem (I think) I am having.  I am sure there is an easy solution but I am not able to figure it out.

In one of my base layers I have 5 button sets, each of which will show a layer of content which in turn will either show another layer or sets a "layer complete" variable and returns to the base layer.  The base layer has a seekbar, no Menu, is set to advance by user and will reset to initial state.

On the base layer, I have a trigger that jumps to another slide if all the layers have been completed (i.e., the variable=true).  At this point, I've tried when timeline ends, starts, reaches x seconds, media completes, etc.  I've "referenced" the variables to confirm they are all set to true (and they are), but the "when" condition never seems to be met when previewing and it just sits there, as if the timeline/seekbar is stuck or never began.  In frustration, I clicked on replay and I received "the target not available message" as if the "when" condition was met, but it started all over again and went into a loop of the "target not available message".

How can I determine what to put for the "when" condition so the slide will jump to its destination?  

6 Replies

This discussion is closed. You can start a new discussion or contact Articulate Support.