I'm a long time user, first time "caller" in these forums. I've scoured the pages searching for a solution to my problem, with no luck. Apologies if it's posted, but I haven't found it.
I have a situation where, if a checkbox is selected, a button to show a layer is enabled. The button is disabled in its original state, becomes enabled when the checkbox beside it is selected, but becomes disabled again when the checkbox is "normal."
I've been playing around with states and triggers, to no avail. I can enable the button by selecting the checkbox, but disabling it is where it gets tricky. Help me E-Learning heroes...you're my only hope.
See attached a quick example of one possible trigger setup. Depending on the state of the checkbox, the state of the button is 'toggled' between Disabled and Normal. Hope that helps.
That was a pretty quick one! We have some amazing community members to assist, and then you'll see staff in the forums as well. If you need anything else feel free to let us know here and you can also always connect with our Support engineers.
6 Replies
See attached a quick example of one possible trigger setup. Depending on the state of the checkbox, the state of the button is 'toggled' between Disabled and Normal. Hope that helps.
Well I'll be....that was quick!
That's exactly what I'm looking for, I just couldn't get it right. Fantastic, Michael, you have my thanks!
W
Hi Wahty,
I just wanted to welcome you to the forums and I'm glad Michael was able to assist you here.
Hi Ashley,
I was pleasantly surprised by the speed of the response! Great introduction to the forums.
Thanks again,
W
That was a pretty quick one! We have some amazing community members to assist, and then you'll see staff in the forums as well. If you need anything else feel free to let us know here and you can also always connect with our Support engineers.
Great! Thanks again, Ashley!
This discussion is closed. You can start a new discussion or contact Articulate Support.