Failure and Success Layers not Appearing in Quiz

Dec 03, 2015

I have a simple 5 question quiz using a corporate template that we have used many times before.   Also, there is an intro slide and results slide.

When the last question is submitted, neither the Success or Failure layers will appear. Also, Score is zero no matter what.

Anyone have an idea what is wrong?

ps: A sterilized version of the quiz is attached.

 

7 Replies
Christie Pollick

Hi, Steve -- Thanks for sharing your file and I will gladly do some testing for you momentarily to see if I encounter the same behavior. In the meantime, just so you have it readily available, here is our System Requirements sheet, and you may want to check out this information on testing your published output in the intended environment. If issues persist, please also see this info on Unexpected or Erratic Behavior in SL2

STEVEN CHORNY

fyi-

The same template (for quizzes) is being used in over 100 courses at my
clients site. I do not believe that is the issue.

fyi- I did have some strange issues with this particular module that I
fixed by deleting some slides and rebuilding them (see my previous post
about background images not sizing properly). My suspicion is the
variables, might be some corruption that is causing this.

Regards.. Steve

Steve Chorny | trainingpro@gmail.com | 647.984.7440 | Mississauga, ON,
Canada |

http://ca.linkedin.com/in/elearningpro

Content Development — Instructional Design — e-Learning Creation — Content
Creation — Project Management
Canadian Society for Training & Development
American Society for Training & Development
eLearning Guild

Christie Pollick

Hi, Steve -- Thanks for sharing your file and I better understand the behavior you have described, and I experienced the same. I would really like for our Support Engineers to dig a little deeper and make some suggestions you could try to address this issue, so I have gone ahead and submitted a ticket on your behalf. You will be hearing from someone shortly and your continued patience is appreciated! :)

This discussion is closed. You can start a new discussion or contact Articulate Support.