In slide 1.2, 1.4, 1.6, 1.8, I reset those slides to initial state when revisiting. However, those slides seem no reset (the last selection is resumed still) and influence the variables in slide 1.4. Thanks!
(Btw, please select the female character at the beginning, slide 1.1)
Looking at the file some of these slides will not reset properly because you have triggers to change state of objects based on variable values (variables values will be persistent across slides and are not affected by revisit values).
also as Tom points out 1.6 and 1.8 are resume saved state, 1.4 is automatically decide and because it is interactive will almost always be resume saved state.
Difficult to test further because a lot of it doesn't work yet.
Thank you for the information. What you mean is that the reset to initial stats is not workable in the case if I use variables and change the state based on variable values.
Because it's a process and allow user to go back when some tests fail, what can I do to let user restart the selection at the beginning?
(I changed 1.6 and 1.8 to reset to initial state when revisiting.)
5 Replies
Didn't look at everything but these slides are not set to initial state
1.6 = resumed saved state
1.8 = resumed saved state
Looking at the file some of these slides will not reset properly because you have triggers to change state of objects based on variable values (variables values will be persistent across slides and are not affected by revisit values).
also as Tom points out 1.6 and 1.8 are resume saved state, 1.4 is automatically decide and because it is interactive will almost always be resume saved state.
Difficult to test further because a lot of it doesn't work yet.
Hi Tom,
Thanks for correcting. I set them wrong and didn't notice that.
Hi Phil,
Thank you for the information. What you mean is that the reset to initial stats is not workable in the case if I use variables and change the state based on variable values.
Because it's a process and allow user to go back when some tests fail, what can I do to let user restart the selection at the beginning?
(I changed 1.6 and 1.8 to reset to initial state when revisiting.)
Hi Venny,
Should the learners restart the section on slide 1.1?
If so, could you reset the variables back to their initial values when the timeline starts on that slide?
This discussion is closed. You can start a new discussion or contact Articulate Support.