I have two slides in my Storyline file that show multiple "jump to slide" triggers in the Story View diagram, however, in the Player Triggers section, correctly, there is only one trigger with a "jump to slide" command. Where did these second "jump to slide" triggers come from and how do I remove them? I did try duplicating the last slide and, when I do, the original last slide works fine and the new duplicated slide has the multiple triggers.
After working more on this project, I've discovered that this is happening only on Quiz slides and what Storyline is doing is to automatically "jump to the next sequential slide" whereas I want to go to a "home slide (1.1)" after the last quiz question in each section. Is there a way to direct Storyline to go to a specific slide after a quiz question rather than going to the next sequential question?
The triggers that Storyline automatically adds are editable. With Quizzes though, the "jump to the next slide" triggers are on the "Continue " buttons on the Correct and Incorrect feedback layers. If you go to both layers and open the trigger, you can specify which slide to go to next.
It looks like Jill has you covered here in regards to where the triggers are located for quiz slides, and you can determine which slide it jumps to - just open up each trigger and where you'd see "next slide" you'll want to use that drop down menu and select the particular slide (home slide 1.1.).
Hi Paresh. It sounds like you want something to change on multiple slides based on a single action. This is the perfect job for variables! If you have the learner perform an action, it can adjust a variable. On each slide you need the change to occur, create a trigger for that change to happen when the timeline starts, and add a condition so it will only happen when the variable has the right value.
Variables carry their value from slide to slide, and they're a great way to influence the actions of many slides with a single action!
7 Replies
After working more on this project, I've discovered that this is happening only on Quiz slides and what Storyline is doing is to automatically "jump to the next sequential slide" whereas I want to go to a "home slide (1.1)" after the last quiz question in each section. Is there a way to direct Storyline to go to a specific slide after a quiz question rather than going to the next sequential question?
Hi Rhonda,
The triggers that Storyline automatically adds are editable. With Quizzes though, the "jump to the next slide" triggers are on the "Continue " buttons on the Correct and Incorrect feedback layers. If you go to both layers and open the trigger, you can specify which slide to go to next.
Hope this helps!
Jill
Hi Rhonda,
It looks like Jill has you covered here in regards to where the triggers are located for quiz slides, and you can determine which slide it jumps to - just open up each trigger and where you'd see "next slide" you'll want to use that drop down menu and select the particular slide (home slide 1.1.).
It worked! Thank you so much for your help!
Thanks Rhonda for the update!
Any Expert can help me ?
I want to do trigger change on multiple slides by single time change.
or change in player.
Hi Paresh. It sounds like you want something to change on multiple slides based on a single action. This is the perfect job for variables! If you have the learner perform an action, it can adjust a variable. On each slide you need the change to occur, create a trigger for that change to happen when the timeline starts, and add a condition so it will only happen when the variable has the right value.
Variables carry their value from slide to slide, and they're a great way to influence the actions of many slides with a single action!
This discussion is closed. You can start a new discussion or contact Articulate Support.