I have a slide with a list of radio buttons and they are not in a set. When the user selects a button I have a trigger for a state change to a corresponding picture. I want the state to go back to normal if the user "unselects" the radio button and I cant seem to get it to work. See trigger for explorer. Any suggestions are appreciated. It doesnt have to be radio buttons, just want something simple without a lot of variables. Thanks!
See attached a file with the first two radio buttons revised. Look at their triggers, their conditions and order and you should be able to replicate this for the remaining radio buttons. Hope that helps.
I'm having a similar issue - when a user clicks on a radio button, I'm displaying a layer with a red X. I want the layer to disappear when they unclick the radio button, but I can't seem to get it to work. Thanks for any suggestions!
I tried looking at Michael's file, but it's just displaying as code. I'm attaching the .story file (I've also posted a separate question in this forum for the same slide).
Glad to hear it - I've seen a few users have difficulty opening older files, not sure of the cause though. Looks like Michael saved the day in the other thread as well :)
9 Replies
See attached a file with the first two radio buttons revised. Look at their triggers, their conditions and order and you should be able to replicate this for the remaining radio buttons. Hope that helps.
THANK YOU!!!!!
I'm having a similar issue - when a user clicks on a radio button, I'm displaying a layer with a red X. I want the layer to disappear when they unclick the radio button, but I can't seem to get it to work. Thanks for any suggestions!
Did Michael's file work for you?
Hi Eric!
Did you take a look at Michael's file shared here?
Would you be able to share your .story file? That may be an easier way for someone to assist you.
I tried looking at Michael's file, but it's just displaying as code. I'm attaching the .story file (I've also posted a separate question in this forum for the same slide).
Thanks!
Not sure why you would not be able to access Eric, but I'll re-attach in case that was the issue.
It looks like Cary is assisting you in your newer thread here as well.
Thank you so much!!! This worked!
Glad to hear it - I've seen a few users have difficulty opening older files, not sure of the cause though. Looks like Michael saved the day in the other thread as well :)
This discussion is closed. You can start a new discussion or contact Articulate Support.