One of my slides has a very short voice over. When I view it in the player, the seek bar at the bottom keeps going for several seconds after the talking is done. I've tried looking at the audio and it doesn't show any additional silence when the voice over is complete, so why does it look that way in the seek bar on the player? Is there a way to adjust that?
Not sure if I am talking about the same thing but I think I have ran into this issue a couple of times before, when resizing a slide. Not quite sure why it happens, but sometimes I somehow manage to resize the audio portion of my timeline. Usually removing and then re-importing your audio file will restore your audio duration (relative to the timeline). Then you can safely adjust your timeline as needed.
3 Replies
Hello Gina,
Check your Timeline.
Make sure that your timeline is only as long as your audio file. If not.. then that will explain why it continues even after the voice over is done.
Not sure if I am talking about the same thing but I think I have ran into this issue a couple of times before, when resizing a slide. Not quite sure why it happens, but sometimes I somehow manage to resize the audio portion of my timeline. Usually removing and then re-importing your audio file will restore your audio duration (relative to the timeline). Then you can safely adjust your timeline as needed.
Hope this helps,
Alex
Thanks so much... I didn't think to check the timeline! That was it!
This discussion is closed. You can start a new discussion or contact Articulate Support.