I have a short bit of audio introducing a few slides in a course I am creating (my first). I would like the audio to complete before the user can click on tabs or videos. It seems like it should be easy but I can't seem to figure it out. Any ideas?
It sounds like you want something to happen when the audio ends; allow the learner to interact with your content.
In the example below, I created a button that when clicked shows a new layer. I made the initial state of the button disabled. I slected the butotn and added a trigger to change the state of the button to normal when the media completes.
3 Replies
Hi Jane and welcome to Heroes!
I assume you want your other elements in the slide containing audio to be visible, just not clickable, right?
In this case, you could place hotspots over those clickable elements and adjust their duration in the timeline, so it matches the audio.
Let me know if it helps,
Alex
It sounds like you want something to happen when the audio ends; allow the learner to interact with your content.
In the example below, I created a button that when clicked shows a new layer. I made the initial state of the button disabled. I slected the butotn and added a trigger to change the state of the button to normal when the media completes.
Hope this helps.
Thank you both so much, this is very helpful!
This discussion is closed. You can start a new discussion or contact Articulate Support.