I have multiple consecutive slides with mouse cursors. I slightly adjusted the end point where the cursor ends on a slide and now the cursor starting point on the on the next slide is not in the same exact starting position as the previous slide. When I play the project the cursor "jumps" a bit to the right. Does anyone have suggestions on how to re-sync the mouse cursor end/start points?
Hi, Paul -- Sorry to hear of the unusual behavior you are experiencing. Would you be able to share your .story file so that we are able to take a closer look for you?
In the meantime, there are a few standard troubleshooting steps we can run through to rule out the causes of some common issues. Please make sure you are working locally as described here, and you may want to try importing the file into a new file. If you are still having issues, you might want to try to repair Storyline. Also, could you please ensure that you are utilizing the most recent SL2 Update? Info on Update 5 can be found here.
1 Reply
Hi, Paul -- Sorry to hear of the unusual behavior you are experiencing. Would you be able to share your .story file so that we are able to take a closer look for you?
In the meantime, there are a few standard troubleshooting steps we can run through to rule out the causes of some common issues. Please make sure you are working locally as described here, and you may want to try importing the file into a new file. If you are still having issues, you might want to try to repair Storyline. Also, could you please ensure that you are utilizing the most recent SL2 Update? Info on Update 5 can be found here.
This discussion is closed. You can start a new discussion or contact Articulate Support.