Replay button does not replay entire slide May 14, 2015 By Shawn McCreight Has anyone else had this issue where when you have layers the replay or rewind button only replays or rewinds the layer you are on? Both the base and additional layers are set to "reset to initial state".
Ashley Terwilliger-Pollard Staff almost 9 years ago05/14/15 at 8:49 pm (UTC) Hi Shawn, Yes, if you have enabled each slide layer to be reset as well, and allow for seeking - than it's treated as separate from the base layer and therefore you could only rewind the portion you're on.
Shawn McCreight Author almost 9 years ago05/14/15 at 8:54 pm (UTC) thanks Ashley, unfortunately they are as you described as above.
Ashley Terwilliger-Pollard Staff almost 9 years ago05/14/15 at 8:59 pm (UTC) Thanks Shawn, than it sounds like it's working as expected.
3 Replies
Hi Shawn,
Yes, if you have enabled each slide layer to be reset as well, and allow for seeking - than it's treated as separate from the base layer and therefore you could only rewind the portion you're on.
thanks Ashley, unfortunately they are as you described as above.
Thanks Shawn, than it sounds like it's working as expected.
This discussion is closed. You can start a new discussion or contact Articulate Support.