Hi everybody, I have a video in my slide as part of the base layer.
Throughout the video, clickable information icons pop up, and the video is paused until the user clicks on the icon. When the user clicks on the icon, they see a new layer with additional information, and once they read it, and click the continue button, the video resumes until the next information icon pops up, and so on.
My question is, how can I add a “replay” button at the end of the video that will replay not only the video, but also the timeline with the icons, and layers, etc.
However, I already tried that, and the problem is when the first information icon and layer pops up with the "continue" button, the whole video starts over again, rather than continuing to the next information icon.
I would like the video and timeline to start over, but only after the user views the entire video once.
3 Replies
On your replay button, add a trigger that jumps back to the same slide and set the slide properties to Reset to Initial State.
Oh, and the replay button should start out as Hidden and is set to Normal when media videoxyz completes (or when the slide timeline ends).
Hi Michael,
Thanks for reaching out and your help!
However, I already tried that, and the problem is when the first information icon and layer pops up with the "continue" button, the whole video starts over again, rather than continuing to the next information icon.
I would like the video and timeline to start over, but only after the user views the entire video once.
Any other thoughts? Thank you again!
This discussion is closed. You can start a new discussion or contact Articulate Support.