results slide won't show success or failure Jul 31, 2013 By Olga Błaszczyńska Hello! I just finished my first Articulate e-learning but I have a small problem with results slide. Although it shows the correct score and %, it won't show the success or failure layer at the same time. What can I do? For success layers the trigger is: Show layer "success" when the timeline starts if results.score point is greater or equals 40,00. There are 5 questions in the test, each gets 10 points.
Olga Błaszczyńska Author over 10 years ago07/31/13 at 6:33 am (UTC) What's more, it show's the failure layer when I preview only this results slide, but when I do the test, there is no message.
Leslie McKerchie Staff over 10 years ago07/31/13 at 10:33 am (UTC) Hi Olga! If you could share your .story file either here in the forum or here in a case, I think someone would be better able to assist you.
Olga Błaszczyńska Author over 10 years ago08/06/13 at 11:10 pm (UTC) That's how it looks like. untitled1.story
Leslie McKerchie Staff over 10 years ago08/09/13 at 8:44 am (UTC) Olga, sorry for the delay. I am not seeing that behavior based on what you have sent. If this is still occurring for you, I think you should submit a case so that support can assist you.
4 Replies
What's more, it show's the failure layer when I preview only this results slide, but when I do the test, there is no message.
Hi Olga! If you could share your .story file either here in the forum or here in a case, I think someone would be better able to assist you.
That's how it looks like.
Olga, sorry for the delay. I am not seeing that behavior based on what you have sent. If this is still occurring for you, I think you should submit a case so that support can assist you.
This discussion is closed. You can start a new discussion or contact Articulate Support.