in the attachment file, I have two shapes that show different layers. for the second attempt the yellow one works properly but the blue one doesn't work.
the only difference is a button inside the second layer.
Parham, I took a very quick peek at your Story file. I was able to get your Blue layer button to work on second and subsequent attempts by setting the Slide (Layer) properties for Revisits to Reset to initial state. I am not sure I understand why the addition of the Button and trigger for the Video layer prevents your Blue button from working on additional attempts, but if I remove that button, then the Blue layer works every time. Hope this helps.
Have a look at the attached and see if that`s what you wanted. On layer Card2, I changed the trigger on card1_1 to Show Layer 2 and also set the layer properties to Reset to Initial State.
3 Replies
Parham, I took a very quick peek at your Story file. I was able to get your Blue layer button to work on second and subsequent attempts by setting the Slide (Layer) properties for Revisits to Reset to initial state. I am not sure I understand why the addition of the Button and trigger for the Video layer prevents your Blue button from working on additional attempts, but if I remove that button, then the Blue layer works every time. Hope this helps.
Have a look at the attached and see if that`s what you wanted. On layer Card2, I changed the trigger on card1_1 to Show Layer 2 and also set the layer properties to Reset to Initial State.
Perfect. Worked.
Thank you Eric and Michael.
This discussion is closed. You can start a new discussion or contact Articulate Support.