I have a layer that I want to show AFTER all my other slides have been shown. Right now it is set to change to visited state, but that won't change the layer. Any ideas? SL2
Without seeing your file it's difficult to guess what the problem might be. Have a look at this example and see if that's what you want to achieve: http://dev.keypointlearn.com/xcl71_SL/SevenTopics/ If yes, I can post the .story file.
You could use variables and triggers so that when all of the variables are true, the last slide viewed jumps to the slide with the layer. Then you would have to have a trigger to show layer if all of the variables were true again.
It might be easier if the layer you want to show at the end was its own slide.
2 Replies
Without seeing your file it's difficult to guess what the problem might be. Have a look at this example and see if that's what you want to achieve: http://dev.keypointlearn.com/xcl71_SL/SevenTopics/ If yes, I can post the .story file.
You could use variables and triggers so that when all of the variables are true, the last slide viewed jumps to the slide with the layer. Then you would have to have a trigger to show layer if all of the variables were true again.
It might be easier if the layer you want to show at the end was its own slide.
Cheers, Julie
This discussion is closed. You can start a new discussion or contact Articulate Support.