When I take and pass my quiz on a retry I get the failure layer and not the success layer. How would you write a trigger to show the success layer after a successful quiz retry?
The problem appears to be with my counter. I have an assessment at the end of my course, and I wanted to give my learners one more attempt so I disabled my retry quiz button after attempts = 1. Since my counter was set at 1, I must have been confusing the system. I set attempts = 2 and it's working fine. Apparently an assessment at the end of a course is not treated as an attempt.
4 Replies
You shouldn't have to write a trigger for that it would show automatically.
Can you share a slide?
Hey Jim - Looks like I just replied to a similar question here as well. Just wanting to link the two for anyone following along.
The problem appears to be with my counter. I have an assessment at the end of my course, and I wanted to give my learners one more attempt so I disabled my retry quiz button after attempts = 1. Since my counter was set at 1, I must have been confusing the system. I set attempts = 2 and it's working fine. Apparently an assessment at the end of a course is not treated as an attempt.
Ah, that makes sense Jim. Glad you were able to get that figured out. Thanks for popping in to share.
This discussion is closed. You can start a new discussion or contact Articulate Support.