Simple Audio Question
Feb 25, 2016
By
Matt Harris
Hi all! I have a slide where my voiceover ends at 56 seconds. In the audio editor there is a vertical dotted line at 58 seconds. That's where I want it to end and progress to the next slide (I have auto-progress in the slide settings options). I have had no problems with other slides but for some reason, when I publish and play this slide about 2 minutes of blank audio is inserted after the 58 seconds. I have tried cropping what I want and resaving but that doesn't work... it all looks great on the audio editor... the slide not going past 58 seconds. Any idea what I am doing wrong? Thanks!.
3 Replies
Hey Matt
can you upload that slide and the slide that follows - easier for someone to help you if they can see your setup.
Hello Matt,
It is difficult to say why it plays longer than the audio. Is your timeline the same length as your audio?
You could try to remove the auto progress from the slide and add a trigger:
Jump to next slide when media completes [your audio].
Hi, Matt -- Like Wendy and Jonas, I also cannot say that I have heard of this particular type of issue before! In addition to sharing your file, you may also want to consider importing your entire file into a new file to see if you find improvement, and it may be helpful to run through the troubleshooting steps listed here, also.
This discussion is closed. You can start a new discussion or contact Articulate Support.