My slide will not stop on my under my squares correctly. Also, when the slider stops, I would like the button it stops at to change states. Not sure what I'm doing wrong.
The slider just needed to be adjusted in size to make it stop under each option. The state changes you put in work correctly, however, i think you just werent releasing the slider. The slider doesn't "move" until you let go of the mouse button when dragging it.
A series a triggers should be added to change each option back to the normal state when the slider moves and != the selected amount. I did this in the attached story.
I also set the initial state of the 1st option to selected since that is where the slider starts.
Have a look at the attached file and see if that's what you want. I added the buttons to a button set so that only one is selected at any given time and adjusted the postions and width of the slider.
4 Replies
The slider just needed to be adjusted in size to make it stop under each option. The state changes you put in work correctly, however, i think you just werent releasing the slider. The slider doesn't "move" until you let go of the mouse button when dragging it.
A series a triggers should be added to change each option back to the normal state when the slider moves and != the selected amount. I did this in the attached story.
I also set the initial state of the 1st option to selected since that is where the slider starts.
Have a look at the attached file and see if that's what you want. I added the buttons to a button set so that only one is selected at any given time and adjusted the postions and width of the slider.
The button set is the better option, as it updates as you drag instead of after your drag.
Michael...that is exactly what I wanted. Thank you so much...you too David!!!
This discussion is closed. You can start a new discussion or contact Articulate Support.