Attached you can find an issue I'm facing and currently I don't know how to deal with it, to be honest.
The slider works fine if you go from point 1 to 4, but if you want to get back it stays in the same place, but the slide changes. If you want to skip two, it just breaks and there's no way to get it back to correct position.
Have you got any experience in that? Or perhaps should I set the slider in some other way?
Since you are using different sliders with different variables, you need to explicitly set the start value for each slider variable as I have done in the attached. This way, this slider thumb is moved to the correct starting position when you revisit a slide.
thanks a lot for your help. One question though: how would I know which slider to put in the variable? I noticed you use slider5, slider11 and some others... I tried to have them consistent, but it didn't work. Or should I just copy/paste the exact interactions you sent me?
With a slider selected, click the Design tab to see which variable is connected to a slider. I didn't want to completely "break" your setup, but I would use the same variable for all sliders.
4 Replies
Since you are using different sliders with different variables, you need to explicitly set the start value for each slider variable as I have done in the attached. This way, this slider thumb is moved to the correct starting position when you revisit a slide.
Hi Michael,
thanks a lot for your help. One question though: how would I know which slider to put in the variable? I noticed you use slider5, slider11 and some others... I tried to have them consistent, but it didn't work. Or should I just copy/paste the exact interactions you sent me?
Thanks,
Arek
With a slider selected, click the Design tab to see which variable is connected to a slider. I didn't want to completely "break" your setup, but I would use the same variable for all sliders.
Hey, worked like a charm!
This discussion is closed. You can start a new discussion or contact Articulate Support.