Is there an actual .story file out there that can be shared? I like to know how to use the slider like it's used in this course. I believe Tom and/or David created it.
I'm not sure if you meant to link to a particular example - but there are a few ideas in this thread for how to use sliders (not specific to a safety course) that you may want to take a look at.
I think you're referring to Tom's post on October 7th. There's a link to the Slider demo in his post. Not sure if he's sharing the .story file, but I'm sure he'll let us know if he sees this thread ... or perhaps staff will nudge him in this direction
4 Replies
Hi Robbin,
I'm not sure if you meant to link to a particular example - but there are a few ideas in this thread for how to use sliders (not specific to a safety course) that you may want to take a look at.
Hi Robbin,
I think you're referring to Tom's post on October 7th. There's a link to the Slider demo in his post. Not sure if he's sharing the .story file, but I'm sure he'll let us know if he sees this thread ... or perhaps staff will nudge him in this direction
Thanks Rebecca - I wasn't sure which one it was.
I'm working on a follow up post, so the source file will be available then. It's a pretty simple demo, though.
The trigger is set to show layer X when value of the slider equals X.
There are 6 steps (I think). The slider is set to have values 1-6.
This discussion is closed. You can start a new discussion or contact Articulate Support.