I have created an IT compliance module but seem to have encountered an issue.
There is a quiz which requires users to pass to complete the module although it is only showing 7 out of 8 questions unless they fail and re do the test. At this point of restarting they are then given all 8 questions to answer.
hard to say without seeing your file. Can you share the .story file - easier for people to offer a solution if they can work with your specific set-up. Just use the grey 'add attachment' button at the bottom of the post to upload.
Looks like you've uploaded the published file - if you can share the source file that you created in Storyline - the one with the .story extension that allows us to look 'under the hood' and see what's going on.
I am only seeing 6 quiz questions ticked in your result slide - which other slides should be included? Slide 1.16? that would give you 7 not sure which is the 8th one to be included. When I ran through your published file the six slides below were the only ones that I was presented with both times.
I am sorry it should be 6 questions overall but only 5 are showing up until they try and re take the quiz? Slide number 1.12 seems to be the one that isn't functioning properly?
I think you had some strange navigation happening because the slides were out of number order, I corrected the order and switched them to jump to next slide.
9 Replies
Hi Mikey
hard to say without seeing your file. Can you share the .story file - easier for people to offer a solution if they can work with your specific set-up. Just use the grey 'add attachment' button at the bottom of the post to upload.
This post was removed by the author
Hi Mikey
Looks like you've uploaded the published file - if you can share the source file that you created in Storyline - the one with the .story extension that allows us to look 'under the hood' and see what's going on.
Sorry please find the correct upload.
Thanks :)
Hi Mikey
I am only seeing 6 quiz questions ticked in your result slide - which other slides should be included? Slide 1.16? that would give you 7 not sure which is the 8th one to be included. When I ran through your published file the six slides below were the only ones that I was presented with both times.
I am sorry it should be 6 questions overall but only 5 are showing up until they try and re take the quiz? Slide number 1.12 seems to be the one that isn't functioning properly?
thanks
Hi Mikey
see the attached Peek video that shows how I re-ordered the last quiz slide to be before the result slide - I think that could have been an issue.
I've also attached the updated .story file. Hope this helps
I think you had some strange navigation happening because the slides were out of number order, I corrected the order and switched them to jump to next slide.
Wendy Farmer the hero! Thank you very much for your help and patience with this
Mikey :)
Glad to help Mikey - good luck with your project!
This discussion is closed. You can start a new discussion or contact Articulate Support.