I'm trying to do software simulations in "try mode." I've recorded some tests, but the narration I added while recording only plays in "view mode," with the entire screen recording loaded on a single slide. When I use "try mode" the narration doesn't play. I need to use try mode.
This is the expected behavior. Below is an excerpt from this tutorial:
If you recorded audio with your screencast, it won't be included with step-by-step slides. However, it'll still be available in the original screen recording in case you want to insert it as a video on a single slide.
It would have been nice if the video I watched on youtube or the E-Learning Uncovered book had mentioned this fact. Thanks for the quick reply.
Sincerely--
Dale Osborn
Training Developer II
Research Administration Project
Michigan State University
4700 S. Hagadorn Road, Suite 100
East Lansing, MI 48823
Ph. 517-353-3121 ext. 555
3 Replies
Hi Dale!
This is the expected behavior. Below is an excerpt from this tutorial:
If you recorded audio with your screencast, it won't be included with step-by-step slides. However, it'll still be available in the original screen recording in case you want to insert it as a video on a single slide.
Thanks, Leslie-
It would have been nice if the video I watched on youtube or the E-Learning Uncovered book had mentioned this fact. Thanks for the quick reply.
Sincerely--
Dale Osborn
Training Developer II
Research Administration Project
Michigan State University
4700 S. Hagadorn Road, Suite 100
East Lansing, MI 48823
Ph. 517-353-3121 ext. 555
[MSU helmet]
No problem Dale.
Also, please note that replying to the forums via e-mail attaches your signature. You are welcome to pop in and edit if needed.
This discussion is closed. You can start a new discussion or contact Articulate Support.