State of Button 1 and Button 2 are visited Mar 14, 2014 By Thomas Hall Hello! Please take a look at the attached screen shot. For reasons unknown, when I preview this slide, after visiting both buttons and returning to the slide, it is not setting Slidecomplete01 to "true". Preventing the course from progressing. The slide properties are set to: Slide Advances: By User When Revisiting: Resume saved state Any ideas? Thanks in advance! Edit: See below for more.
Thomas Hall Author 10 years ago03/14/14 at 3:32 pm (UTC) Michael, I tried setting it up as a condition, but there was no difference. The slide still did not detect that both buttons were visited.
Thomas Hall Author 10 years ago03/14/14 at 4:08 pm (UTC) I was able to get most of the functionality I was looking for using this: The only issue I can't seem to resolve, is getting the incomplete layer to open when re-visiting the slide.
Thomas Hall Author 10 years ago03/14/14 at 4:29 pm (UTC) I solved the incomplete layer issue: ...but now I have another question. Is there a way to make the buttons appear that they have been visited?
Michael Hinze 10 years ago03/14/14 at 4:45 pm (UTC) It may be easier for the community to provide some suggestions if you could post you file (or a portion of it) here.
Ashley Terwilliger-Pollard Staff 10 years ago03/17/14 at 9:53 am (UTC) Hi Thomas, By default the visited state of a button matches that of the normal state, but you can change how it looks to reflect that it has been visited as described here. I also thought this article may be helpful as it describes all the built in states and how they'll behave.
6 Replies
Try setting your 2nd slide trigger s shown here.
Michael,
I tried setting it up as a condition, but there was no difference. The slide still did not detect that both buttons were visited.
I was able to get most of the functionality I was looking for using this:
The only issue I can't seem to resolve, is getting the incomplete layer to open when re-visiting the slide.
I solved the incomplete layer issue:
...but now I have another question.
Is there a way to make the buttons appear that they have been visited?
It may be easier for the community to provide some suggestions if you could post you file (or a portion of it) here.
Hi Thomas,
By default the visited state of a button matches that of the normal state, but you can change how it looks to reflect that it has been visited as described here. I also thought this article may be helpful as it describes all the built in states and how they'll behave.
This discussion is closed. You can start a new discussion or contact Articulate Support.