I am trying to create an activity where learners must assemble parts of an apparatus in a specific order. I can create drag-and-drop actions but I don't know how to put them into a required sequence. Thanks!
So I duplicated the wrench so I could use it twice, I make it hide when it's dropped. It's setup as a Pick One freeform as I wasn't sure if it was a quiz type question.
8 Replies
Hi Rachel
can you share the slide so we can see how you have it setup.
Hi Wendy,
Thanks for responding! The first attachment shows the parts and the second shows them assembled.
The steps are:
1. used the wrench to clear the valve
2. attached the pressure regulator
3. use the wrench to open cylinder one full turn
4. attach delivery device
These aren't actually all the steps. I'm just including a few of them for this example.
Thanks so much for taking a look!
Rachel
Hi Rachel
if you've already set up the slide with the bits it will be easier to try and work a solution in the .story file...can you share the slide?
Sorry about that. Here it is.
Hi Rachel
see if this setup will work - it's pretty crude but it may give you an idea.
Here is a Peek video of it.
So I duplicated the wrench so I could use it twice, I make it hide when it's dropped. It's setup as a Pick One freeform as I wasn't sure if it was a quiz type question.
Wow, you are amazing! Any chance I can get the .story file? I think this will work for my project!
Thank you so much!
Sure - here you go...hope it helps
Shout out if you need any explanation of what I did.
Thanks so much!
This discussion is closed. You can start a new discussion or contact Articulate Support.