Did you happen to have branching slides in this scene at one time? If you did and you deleted some slides, it looks like the remaining slides did not adjust to a larger thumbnail. Try hovering your mouse over the right edge of the thumbnail panel until the mouse becomes a double black arrow, and click and drag the edge like I did here. Does that help?
I have been a bit busy, thank you for getting back to me. I see your screen shot. However, what I am speaking of are the small scenes on the left panel. They are hard to see and was hoping to expand them a bit.
Is that possible?
Have a great day!
Gina Raso
Production Control Center CO6 - 1D095
Ball Aerospace
Office: 303-939-7725 or 303-939-7621
Email: graso@ball.com
If you need immediate assistance, please contact my supervisor, Laura Barkley at extension 4-4109.
This message and any enclosures are intended only for the addressee. Please
notify the sender by email if you are not the intended recipient. If you are
not the intended recipient, you may not use, copy, disclose, or distribute this
message or its contents or enclosures to any other person and any such actions
may be unlawful. Ball reserves the right to monitor and review all messages
and enclosures sent to or from this email address.
Well, this leads me back to Alyssa's first comment about branching because if the course has branching with both vertical and horizontal paths in the StoryView, this would be the default behavior. If you start a new project and add a few slides, does it look as you expect? If you'd like us to take a look at your .story file, please feel free to attach here so that we can be sure.
5 Replies
Hello Gina!
Did you happen to have branching slides in this scene at one time? If you did and you deleted some slides, it looks like the remaining slides did not adjust to a larger thumbnail. Try hovering your mouse over the right edge of the thumbnail panel until the mouse becomes a double black arrow, and click and drag the edge like I did here. Does that help?
Hello,
I have been a bit busy, thank you for getting back to me. I see your screen shot. However, what I am speaking of are the small scenes on the left panel. They are hard to see and was hoping to expand them a bit.
Is that possible?
Have a great day!
Gina Raso
Production Control Center CO6 - 1D095
Ball Aerospace
Office: 303-939-7725 or 303-939-7621
Email: graso@ball.com
If I am unavailable, please see options below.
For EA scheduling please utilize batceasc@ball.com
For M&P scheduling please utilize batcdlsc@ball.com
For HPC scheduling please utilize batchpcsc@ball.com
If you need immediate assistance, please contact my supervisor, Laura Barkley at extension 4-4109.
This message and any enclosures are intended only for the addressee. Please
notify the sender by email if you are not the intended recipient. If you are
not the intended recipient, you may not use, copy, disclose, or distribute this
message or its contents or enclosures to any other person and any such actions
may be unlawful. Ball reserves the right to monitor and review all messages
and enclosures sent to or from this email address.
Hey Gina - Check out my suggestions here and hopefully the scrolling mouse will assist you as well :)
Please note that replying to the forums via e-mail attaches your signature. You are welcome to pop in and edit if needed.
This does not work
Gina Raso
Office: 303-939-7725 (CO6) or 303-939-7621 (CO8)
Well, this leads me back to Alyssa's first comment about branching because if the course has branching with both vertical and horizontal paths in the StoryView, this would be the default behavior. If you start a new project and add a few slides, does it look as you expect? If you'd like us to take a look at your .story file, please feel free to attach here so that we can be sure.
This discussion is closed. You can start a new discussion or contact Articulate Support.