I have variables set up to where they have to click all the related markers and view information before they can go to the next slide. However, it seems like the timeline end is overriding that and all my content goes off the slide before all the markers are clicked. Also, if I go through and click all the markers and then click next, it is not going through until the timeline is complete.
Would you be able to share your file here so I can take a closer look at your specific setup? You're welcome to add it as an attachment right to a comment in this thread. Thanks!
are you using the built in navigation and do you have your menu set to 'restricted'? If so, 'when timeline ends' is normal behaviour before a user can proceed.
Great, Troy! Happy to hear you were able to figure it out. Good luck with the rest of your project and don't hesitate to reach back out here if you get hung up!
4 Replies
Hey Troy,
Welcome to Heroes! Happy you're here :)
Would you be able to share your file here so I can take a closer look at your specific setup? You're welcome to add it as an attachment right to a comment in this thread. Thanks!
Hey Troy
are you using the built in navigation and do you have your menu set to 'restricted'? If so, 'when timeline ends' is normal behaviour before a user can proceed.
Thank you both for the response. I went back and checked, and I had a variable selected twice, so I was missing one.
I am using built in navigation for this one, but in the future will switch to my own navigation buttons. Thanks again!
Great, Troy! Happy to hear you were able to figure it out. Good luck with the rest of your project and don't hesitate to reach back out here if you get hung up!
This discussion is closed. You can start a new discussion or contact Articulate Support.