3 Replies
Wendy Farmer

Hi Celine

I changed the slide properties so that it 'reset to initial state'. Click the cog wheel in the Base layer properties panel. See the story file if this is what you need.

I also updated the Polygon on A2 slide to read A2 as they were both reading A1 and I didn't think the trigger was working

Celine Ling

Hi Wendy,

I have another question,

I have created TOC button on the bottom right, i wish i can click on the TOC button back to the Main Page and re-click on the A button and jump to its slide and resume it. After the 3 slide( A_1, A_2 & A_3) have finish play, when i re-click again on the A button, the 3 slide will reset again (play from the beginning).