Triggers don't work properly when previewing entire project. Feb 26, 2019 By Kelley Miller Hi, When showing previewing in "entire project" the scene and slides below don't work properly. It seems that the triggers are off. However, it works well when showing only the scene. Scene: Five QuizAliasLogin Slide: 5.1 and 5.5 Please advice. J. AliasLastVersion.story
Phil Mayor Hero 5 years ago02/26/19 at 4:32 pm (UTC) Where does it go wrong, I can see you have variables to track try again? Any reason why you are using those over the built in function?
Kelley Miller Author Phil Mayor 5 years ago02/26/19 at 4:50 pm (UTC) Hi, When you preview the entire project, these specific slides 5.1 and 5.5 don't work. But if yuu preview only the scene "Five QuizAliasLogin" the slides work fine. No, I don't need the variables. I created those variables for other slides. I'd like to know how I can fix the problem of the slides (mentioned above) not working properly when previwing the entire project. Any advice? Thank you J.
Kelley Miller Author 5 years ago02/26/19 at 5:01 pm (UTC) I'm going to delete those variables, I have no idea why they are there. It's Crazy!
Phil Mayor Hero 5 years ago02/26/19 at 5:08 pm (UTC) The work fine when I preview and go through the menu (which I enabled) but there are also conditions (unassigned) for the jump scene trigger, not sure why it isn't working but there are a lot of left over its that may be doing it.
Kelley Miller Author 5 years ago02/26/19 at 5:50 pm (UTC) I think I need to clean it up a little. I'll come back after I do that. Thank you
Kelley Miller Author Phil Mayor 5 years ago02/26/19 at 7:04 pm (UTC) I did some clean up. It works fine now. Thank you. J.
6 Replies
Where does it go wrong, I can see you have variables to track try again? Any reason why you are using those over the built in function?
Hi,
When you preview the entire project, these specific slides 5.1 and 5.5 don't work.
But if yuu preview only the scene "Five QuizAliasLogin" the slides work fine.
No, I don't need the variables. I created those variables for other slides.
I'd like to know how I can fix the problem of the slides (mentioned above) not working properly when previwing the entire project.
Any advice?
Thank you
J.
I'm going to delete those variables, I have no idea why they are there.
It's Crazy!
The work fine when I preview and go through the menu (which I enabled) but there are also conditions (unassigned) for the jump scene trigger, not sure why it isn't working but there are a lot of left over its that may be doing it.
I think I need to clean it up a little.
I'll come back after I do that.
Thank you
I did some clean up. It works fine now. Thank you.
J.
This discussion is closed. You can start a new discussion or contact Articulate Support.