Viewing a slide a 2nd time
Aug 13, 2013
By
Rob Morgan
On my training I have multiple slides that have "correct" "incorrect" layer. When the user selects an answer it either goes to the correct or the incorrect layer and from there they click a button to move to the next slide.
The problem is that if someone tries to revisit a slide the last layer they were on is popping up rather than starting the slide over again. I have seen in the player menu where I can choose to let them resume if they navigate away from the training and come back but that does not seem to be the issue. It is when they navigate away from a slide and come back it is not defaulting back to the base layer.
Any thoughts?
6 Replies
Try setting the slide properties to "Reset to initial state', as shown here.
Perfect. I'll have to test it but I think that will do it for me. I knew I had seen something like that before but I didn't need it at the time and I completely forgot where I had seen it.
Thanks!
Rob
Hi Rob! Glad Michael was able to help you out here. Just let us know if you need anything further.
Thanks Michael!
I have 97 slides in this training. Is there a way to easily set "Reset to initial state" to all slides and each layer or will I have to go through and do this for each Slide and slide Layer.
In Storyview, select your 97 slides (e.g. do a CTRL+A), and then change the slide properties in the right panel, as shown below. This will change the properties of the baselayer on al selected slides.
Well there you go! Michael beat me to it. Hope that helps you out Rob!
This discussion is closed. You can start a new discussion or contact Articulate Support.