NEVER MIND - Right after I wrote this I figured out what to do!
I have created many slides, and each slide has multiple layers. Of course, when I went to preview the slide, I am forced to preview every layer. Is there a way to just preview certain layers within a slide, ensuring that all of the animations, actions, and so on are correct? Viewing the entire slide takes so much time.
Not currently. What I usually do is just create some dummy buttons for the layers if I want to see only certain layers. Then delete them when I am done.
That's basically what I did. I use lots of triggers, variables, and so
on. And I just forced the particular layer to show so that I didn't have
to go through everything.
2 Replies
Not currently. What I usually do is just create some dummy buttons for the layers if I want to see only certain layers. Then delete them when I am done.
Thanks.
That's basically what I did. I use lots of triggers, variables, and so
on. And I just forced the particular layer to show so that I didn't have
to go through everything.
Again, thanks for responding.
wade.
This discussion is closed. You can start a new discussion or contact Articulate Support.