Hello! I have tried to figure out where I've gone wrong, but I am at a loss. Hoping someone can help me figure out why the buttons on side 1.2 do not show as visited after clicking on them to move on to their respective scenes. I have attached the file here.
PROBLEM The problem is that your base layer will reset to the initial state. And in the initial state of the base layer, all your buttons have the normal state.
SOLUTION Make use of your variables. Set 3 new triggers (I just show one as an example):
Many thanks! I was banging my head against the wall. I actually just changed slide 1.2 to "Automatically Decide" when revisiting, and that also solved the problem.
2 Replies
Dear Monica,
PROBLEM
The problem is that your base layer will reset to the initial state. And in the initial state of the base layer, all your buttons have the normal state.
SOLUTION
Make use of your variables.
Set 3 new triggers (I just show one as an example):
Kind regards,
Many thanks! I was banging my head against the wall. I actually just changed slide 1.2 to "Automatically Decide" when revisiting, and that also solved the problem.
This discussion is closed. You can start a new discussion or contact Articulate Support.