Continue button not appearing Oct 03, 2018 By J Reyno - Dutton I have three layers that I want visited before the user goes to the next slide. I added a 'continue' button. It's not appearing. This is on slide 1.2. I have something similar on slide 1.4 where the selections branch to other slides and it's working fine. Also, the 'next' button on the timeline is working without going into any of the layers. Mandatory_Reporting_10_2018.story
Michael Hinze over 5 years ago10/03/18 at 4:33 pm (UTC) Have a look at the attached and see if that's what you wanted. The setup of 1.2 is different from 1.4 because you use layers and not separate slides. I used the Complete state of the three buttons to enable the Continue button. Mandatory_Reporting_10_2018_MH.story
J Reyno - Dutton Author over 5 years ago10/03/18 at 4:45 pm (UTC) That works. Looks like I was doing more work than I actually needed. Much appreciation
2 Replies
Have a look at the attached and see if that's what you wanted. The setup of 1.2 is different from 1.4 because you use layers and not separate slides. I used the Complete state of the three buttons to enable the Continue button.
That works. Looks like I was doing more work than I actually needed.
Much appreciation
This discussion is closed. You can start a new discussion or contact Articulate Support.