I created a course and a quiz for the course. At the end of the course the next slide starts the quiz. My question is this; How do I make it so that if a person doesn't pass the quiz that they can just take the quiz again and not go through the entire course again? The participant has to have a 100% in order to pass the course.
1. First make sure the revisit properties for each of your quiz questions are set to"Reset to Initial State"
2. Add a button to the Failure layer on the Quiz Results slide. You can call it Retake Quiz or whatever you want to call it.
3. Add 2 triggers the button. One to Reset the Results and another to Jump to the first slide of the quiz. Note that the trigger to Reset the Result should come before the trigger to jump to the slide.
Thank you for your response. I am truly a beginner with storyline 3. I've been learning as I have been building my course. I say that to say, I have very limited knowledge of what you were referring to. I understand triggers and I understand adding buttons. I cannot find the "revisit properties" to check it's status. Please help again. Thanks.
5 Replies
Hi Lisa,
1. First make sure the revisit properties for each of your quiz questions are set to"Reset to Initial State"
2. Add a button to the Failure layer on the Quiz Results slide. You can call it Retake Quiz or whatever you want to call it.
3. Add 2 triggers the button. One to Reset the Results and another to Jump to the first slide of the quiz. Note that the trigger to Reset the Result should come before the trigger to jump to the slide.
This should do the trick for you.
HI Nancy,
Thank you for your response. I am truly a beginner with storyline 3. I've been learning as I have been building my course. I say that to say, I have very limited knowledge of what you were referring to. I understand triggers and I understand adding buttons. I cannot find the "revisit properties" to check it's status. Please help again. Thanks.
Hi Lisa,
Each slide has a properties button (little gear) toward the bottom right when you're in slide view.
The second dropdown is titled When Revisiting.
Hope this helps!
Thank you Sean, It does!!!
Thanks for jumping in Sean! Lisa let me know if you need any more guidance on this.
This discussion is closed. You can start a new discussion or contact Articulate Support.