I am looking at a way to be able to automatically navigate to another screen once all the areas have been visited. I have tried putting in a trigger which says move to slide ...when the state of all (then selected all boxes) are visited.
This works in principle but the second i select the last box to view the content it moves to the slide without showing the information in the selected box slide first.
Can you share your file here so we can see how you've got this set up? I have a couple of ideas for how to fix this but it depends on what else you've got going on.
Turns out I did't need it to move once all are visited as the learner may not need to view all before moving on, I have just put a simple voiceover in to clarify their next steps.
Will use the example above moving forward though thanks.
6 Replies
Hi Alan,
Can you share your file here so we can see how you've got this set up? I have a couple of ideas for how to fix this but it depends on what else you've got going on.
Thanks! :)
Hi, Alan: Did a quick mockup, which might be of some help (attached). Below is the basic trigger I used. --Daniel
Thank you both,
Turns out I did't need it to move once all are visited as the learner may not need to view all before moving on, I have just put a simple voiceover in to clarify their next steps.
Will use the example above moving forward though thanks.
Alan
I'm glad you were able to find a solution! :)
This post was exactly what I needed! Thank you everyone! :)
Glad it helped. --Daniel
This discussion is closed. You can start a new discussion or contact Articulate Support.