Is there a way to reset a dial back to the intial state. For example, I have a dial that goes from 0-1 (mainly for the rotation effect to look like a lever). I would like for it to reset back after it hits 1.
I only have SL 2 so will compare this to the slider interaction. (hopefully they are similar) Also, I apologize if you have tried this already.
I would try to setup a trigger that sets the variable value of the dial equal to 0 upon an event happening. In the instance I attached, the event is when the variable changes.
I performed the test on the slider in SL2. You will find a screenshot of the trigger and .story file used.
You may have to play with ideas on which events you wish to track depending on the functionality you are looking for.
1 Reply
Hi Mark,
I only have SL 2 so will compare this to the slider interaction. (hopefully they are similar) Also, I apologize if you have tried this already.
I would try to setup a trigger that sets the variable value of the dial equal to 0 upon an event happening. In the instance I attached, the event is when the variable changes.
I performed the test on the slider in SL2. You will find a screenshot of the trigger and .story file used.
You may have to play with ideas on which events you wish to track depending on the functionality you are looking for.
I hope this is helpful.
This discussion is closed. You can start a new discussion or contact Articulate Support.