I'm creating a try mode simulation and the try again, incorrect, correct and and hint slide layers show up with default layer properties that hide other slide layers. Is there any way to set the default properties so hide other slide layers is disabled?
Unfortunately there isn't a way to change that default setting. Perhaps you could explain a bit more about what you're looking to accomplish with showing all layers at once? I am not sure I've seen a set up that accommodates that nor do I fully understand what you'd like to do.
1 Reply
Hi Richard,
Unfortunately there isn't a way to change that default setting. Perhaps you could explain a bit more about what you're looking to accomplish with showing all layers at once? I am not sure I've seen a set up that accommodates that nor do I fully understand what you'd like to do.
This discussion is closed. You can start a new discussion or contact Articulate Support.