Forum Discussion
Order Steps in Process blocks
Hi, Revising my course with a processblock I found I would like to insert another block as step1 and move step1 to step2. Somehow it seams, step 1 is fix after the introduction and this is not working.
Is this the case by design, that step 1 is fix an cant be moved elseware?
Thanks for help and kind regards,
Monika
7 Replies
I'm with SabineStauffer on this one.
I have had this now on a few process blocks where Step 1 seems fixed and no other steps can be placed ahead of it to become step 1.
Any step from 2 onwards can all be moved between each other just fine.
This is very frustrating issue. 😡
I explained how to do this elsewhere in this thread.
To clear any confusion, I am fully aware how the steps are re-ordered in the process block using the drag handles. But the point I was in agreement with Sabine it works fine except it 'appears' Step 1 is locked and can not be moved itself to another position, or another step cant be put before it.
Thanks. this works fine with other stept than step 1. e.g. if you find you want to swich step 1 and step 2, you have to copy content manualy.
I tried this yesterday, and validated it again several times this morning:
You can use the (yellow highlight in my screenshot) drag handles to switch step 1 and step 2 (or any other step).
There is no need to copy content manually.
Click on the Content / Pencil icon.
On the panel that opens, you can add more steps, or change the position of existing steps by dragging them up or down the list as shown below.
