I have no idea why an animation will not start when the module is published to 360. Works fine in preview mode. I am pulling my hair out as I have rebuilt this slide numerous times and cannot see what I am doing wrong. It is so simple... The slide requires you to visit two other slides (from shapes) then when both of those shapes are visited a red box should move across into the screen from the left, at the same time the next button disables. I have this in other slides with no problem.
Please have a look at the story and see if you can see what I am doing wrong. Your help is greatly appreciated.
Sorry Wendy, I went back in and saw what you had done. Thank you.
What I dont understand is why I have to have the conditions set up? I have done this many times before without them. Just having the trigger dependent on the pentagons being in the visited state.
Can you explain why this one is different so I know for next time?
Wendy's example works for me. Setting the trigger to happen when the timeline starts is necessary because you want this motion to happen when you return to this slide if the 2 items are visited.
5 Replies
Hi Kim
I changed your move trigger to 'when timeline starts' and its working
Thanks Wendy but I need it to come in after both pentagons are visited.
Thats where I am having trouble.
Best Regards,
Kim Baker
KMD Consult
Mobile - 0490 851 863
kmdconsultation@gmail.com
Sorry Wendy, I went back in and saw what you had done. Thank you.
What I dont understand is why I have to have the conditions set up? I have done this many times before without them. Just having the trigger dependent on the pentagons being in the visited state.
Can you explain why this one is different so I know for next time?
Cheers
Kim
Hi Wendy,
I have followed the conditions and it still will not move the red rectangle...
Thanks
Kim
Hi Kim,
Wendy's example works for me. Setting the trigger to happen when the timeline starts is necessary because you want this motion to happen when you return to this slide if the 2 items are visited.
This discussion is closed. You can start a new discussion or contact Articulate Support.