Is there a way to sync video and (seperate) audio to the Video Controls in Storyline? For example, I want the video and the (seperate) audio to stop/start when the user clicks the video control button.
Are you using the seekbar, or video controls placed on the video itself?
I don't believe you'll be able to do this using the video controls, but you could make it appear as though this is working. You could create a transparent button or maybe even a hotspot over the "Play/Pause" buttons on the video that would pause and play both media objects.
Not sure if that will work for your project, but I wanted to suggest it, just in case :)
I was trying to use the default video controls placed on the video itself. However, because I couldn't get it to work (the way I wanted), I decided to create a custom video control with play/pause buttons and a trigger for each that plays/pauses both the video and the separate audio at the same time.
I was trying to use the default video controls placed on the video itself. However, because I couldn't get it to work (the way I wanted), I decided to create a custom video control with play/pause buttons and a trigger for each that plays/pauses both the video and the separate audio at the same time.
Thanks again.
Chris.
Hi Chris,
I'm running into the same issue you're describing. How did you create the custom video controls?
5 Replies
Hi Chris,
Are you using the seekbar, or video controls placed on the video itself?
I don't believe you'll be able to do this using the video controls, but you could make it appear as though this is working. You could create a transparent button or maybe even a hotspot over the "Play/Pause" buttons on the video that would pause and play both media objects.
Not sure if that will work for your project, but I wanted to suggest it, just in case :)
Thanks!
Thanks for your reply Christine.
I was trying to use the default video controls placed on the video itself. However, because I couldn't get it to work (the way I wanted), I decided to create a custom video control with play/pause buttons and a trigger for each that plays/pauses both the video and the separate audio at the same time.
Thanks again.
Chris.
Hi there Chris,
Great! That sounds even better :) Glad you were able to set this up and get it working.
Good luck on the project!
Christine
Hi Chris,
I'm running into the same issue you're describing. How did you create the custom video controls?
Agnieszka
Hi Agnieszka! This thread is a bit dated and I'm not sure if Chris is subscribed, so you may want to send him a private message
This discussion is closed. You can start a new discussion or contact Articulate Support.