Nicole Alexander
Nicole Alexander
Beanixx E Designs Pty Ltd
Activity
"This seems simple enough. Thanks for your help. I'm hoping to figure out how to do it without seperating my quizzes into sections, as the..."
  • over 4 years ago08/08/19 at 11:16 am (UTC)
Activity
"Thank you. I will attempt this and see if I can get it right"
  • over 4 years ago08/08/19 at 10:40 am (UTC)
Activity
Nicole Alexander started a new discussion Triggers that will only show slides based on quiz results
"How do I create a trigger/triggers that will only show slides based on quiz results? Is this possible? This course is for re-assessment p..."
  • over 4 years ago08/08/19 at 10:06 am (UTC)
Activity
Nicole Alexander replied to the discussion Record Mic stopped working
"I did that... but still nothing. I restarted my pc, then opened it and all is working fine. Thanks."
  • almost 5 years ago05/01/19 at 1:02 pm (UTC)
Activity
Nicole Alexander started a new discussion Record Mic stopped working
"I recorded 8 clips and then all of a sudden whilst I was busy recording number 9, it just stopped... Attached is a screenshot of what h..."
  • almost 5 years ago05/01/19 at 12:45 pm (UTC)
Activity
Nicole Alexander replied to the discussion Triggers and States stop working
"I re-installed storyline and everything is working perfectly again. Thanks :)"
  • almost 5 years ago04/10/19 at 7:22 am (UTC)
Activity
Nicole Alexander replied to the discussion Triggers and States stop working
"Thanks for getting back to me. I'll attempt a new course. If it persists I'll try the repair option and take it from there."
  • almost 5 years ago04/09/19 at 7:20 pm (UTC)
Activity
Nicole Alexander replied to the discussion Triggers and States stop working
"Is this ok?"
  • almost 5 years ago04/09/19 at 5:49 pm (UTC)
Activity
Nicole Alexander started a new discussion Triggers and States stop working
"Hi I'm having issues with Storyline... I'll set all my triggers, test it out and it's working fine. I'll adjust a few things (timing) a..."
  • almost 5 years ago04/09/19 at 5:14 pm (UTC)