Thomas  Linson
Thomas Linson
Baxter Healthcare
Activity
Thomas Linson replied to the discussion Un-Publishing??
"Yes, I have a published version of the course. I'm in the file folder but don't see .story version of the course. All of the ..."
  • almost 2 years ago08/08/19 at 7:27 pm (UTC)
Activity
Thomas Linson started a new discussion Un-Publishing??
"I've got an older version of a Storyline project that needs to be updated. It was done prior to my joining the company. I can't see..."
  • almost 2 years ago08/08/19 at 1:48 pm (UTC)
Activity
Thomas Linson started a new discussion Un-Publishing??
"I've got an older version of a Storyline project that needs to be updated. It was done prior to my joining the company. I can't see..."
  • almost 2 years ago08/08/19 at 1:46 pm (UTC)
Activity
Thomas Linson replied to the discussion Unruly Layer!
"I think that did it!! Thanks a lot!"
  • almost 2 years ago08/06/19 at 6:22 pm (UTC)
Activity
Thomas Linson replied to the discussion Unruly Layer!
"I'm in the NC office"
  • almost 2 years ago08/06/19 at 6:06 pm (UTC)
Activity
Thomas Linson replied to the discussion Unruly Layer!
"I didn't figure it out, but I did concoct a workaround. I just took the layer and put it on it's own slide. It's working now. Got a..."
  • almost 2 years ago08/06/19 at 5:57 pm (UTC)
Activity
Thomas Linson started a new discussion Unruly Layer!
"I've got a layer that I need to go to the next slide but when I add the trigger to the layer it gets added to the base layer and not on t..."
  • almost 2 years ago08/06/19 at 5:42 pm (UTC)
Activity
Thomas Linson replied to the discussion Delaying Base Layer Actions
"Daniel, Thanks so much for the tip, however, I'm having trouble understanding the last paragraph of your reply. Could you elaborate on ..."
  • over 2 years ago01/18/19 at 2:59 pm (UTC)
Activity
Thomas Linson started a new discussion Delaying Base Layer Actions
"I'm sure the answer is on here somewhere, but I haven't been able to find it. My question is: Can you delay base layer actions until af..."
  • over 2 years ago01/17/19 at 6:45 pm (UTC)