Drag and drop snap Dec 11, 2018 By Curtis Wiens I have - return item to start point if dropped outside: a correct drop target CHECKED. This works unless I add a trigger to show a layer when the answer is correct or incorrect. Anyone else seen this: https://360.articulate.com/review/content/bf9962e3-3e65-4d65-920a-ac7152a8eaad/review
Tom Kuhlmann Staff over 5 years ago12/11/18 at 10:20 pm (UTC) There may be a conflict: You have a command to return the object You have a trigger to show layer I assume the trigger is first which drops the object on the shape. Thus not allowing it to jump back since it's locked into the shape. Here's a solution that may work
Curtis Wiens Author Tom Kuhlmann over 5 years ago12/12/18 at 5:17 pm (UTC) Thanks so much! Appreciate the detailed response.
Curtis Wiens Author over 5 years ago12/12/18 at 5:30 pm (UTC) Wow, thanks so much. That is a much easier way to set up a custom drag and drop too!
3 Replies
There may be a conflict:
I assume the trigger is first which drops the object on the shape. Thus not allowing it to jump back since it's locked into the shape.
Here's a solution that may work
Thanks so much! Appreciate the detailed response.
Wow, thanks so much. That is a much easier way to set up a custom drag and drop too!
This discussion is closed. You can start a new discussion or contact Articulate Support.