Forum Discussion
One button to switch between layers
Hello,
Is there a way to have one hotspot that can trigger a switch from one layer to the next? I have a picture of a device that my learner uses on the job. When a certain button on the device is pushed, it changes the view on the device's screen. The same button is pushed to change the view again. I have a hot spot over the picture of the button, and I have 3 layers to show 3 different view changes. I want to know if I can set it up so that the learner can select the same hotspot multiple times and each time it will show a different layer.
Hi Jaclyn
can you share the slide so we can see what you have setup - easier for someone to help with your example.
here is a rough sample - it means having a HS on each layer unless I am misunderstanding your requirement
Wendy jumped in as I was recording a tutorial, here's a way to do it.
Good example of two different ways to do what you want. In Wendy's you can create triggers at the layer level which may give you more granular control based on what you want to trigger.
In my example, I used a number variable that cycles through the number and shows layers based on that. Really just depends on what you want to do.
This is exactly what I needed!! Thank you, Tom and Wendy, for taking the time to provide these examples. Both are great ideas. It's good to know there's more than one way to do it. Thank you so much for your help! :)
