Can anyone help me figure out why my bar graphs associated with this slider are acting so weird?
When burnout is low, I want the turn over low, patient satisfaction higher, and medical errors very low.
When in the center, I want the turn over to be slightly higher than the first one, patient satisfaction down a bit, and medical errors up a little bit.
When burnout is high, I want turn over very high, patient satisfaction very low, and medical errors very high.
Thank you for getting back to me!! I have another question, if you don't mind :) Do you know why the bar graphs seem to disappear when I move the slider?
It looks like it's the way the states built. If you take a look at the states panel for each of your rectangles, they do seem to jump around a bit and modifying them should alleviate the issue you're running into when using your slider.
4 Replies
Hi Heather!
Looks like it's just a setting we need to change! You'll want to add a larger number for the "End" on the slider,
I'll show you here!
Thank you for getting back to me!! I have another question, if you don't mind :) Do you know why the bar graphs seem to disappear when I move the slider?
Hi Heather,
It looks like it's the way the states built. If you take a look at the states panel for each of your rectangles, they do seem to jump around a bit and modifying them should alleviate the issue you're running into when using your slider.
I got it figured out, thanks to your help!! Thank you very much :)
This discussion is closed. You can start a new discussion or contact Articulate Support.