Can someone please help me, I am not sure what is the correct trigger to use to enable the continue button to show and move to the next slide.
Not sure if I should change the anything in the continue button state? because after the 3rd layer, the continue button doesn't appear so that i can click on it and move on to the next slide when I preview "entire project"
Here's one approach. I used variables. I added one T/F variable for each layer that is set to true when the layer is viewed. There is also a trigger added to each layer and to the base layer that sets the Continue button state to Normal if all three variables are set to true.
1 Reply
Hi Prudence,
Here's one approach. I used variables. I added one T/F variable for each layer that is set to true when the layer is viewed. There is also a trigger added to each layer and to the base layer that sets the Continue button state to Normal if all three variables are set to true.
This discussion is closed. You can start a new discussion or contact Articulate Support.