Forum Discussion

DeveloperIgniti's avatar
DeveloperIgniti
Community Member
2 days ago

Corner radius of zero is visibly not zero until you manually reset it.

Hi,

I have found an odd behaviour - when adding a "continue" button to a Rise course, its corner radius is set to zero, but it is visibly not zero - I can see it has slightly soft corners (best seen with a screenshot and zooming in).

If I open the Format editor, move the corner radius slider up to a non-zero value, then back down to zero, the corner radius does visibly become zero and the button corners are pin sharp.

Would be great if anyone can reproduce this.

Many thanks in advance.

rise 360

2 Replies

  • StevenBenassi's avatar
    StevenBenassi
    Staff
    7 hours ago

    Hi DeveloperIgniti​ & PhilFoss​,

    Thank you for highlighting this issue.

    I've logged this as a bug in Rise 360. This bug causes:

    • Corner Radius Formatting defaults to a 2px value for Continue Block Buttons

     

    I've included both of you in the bug report so we can notify you as soon as a fix is ready. As you've mentioned, increasing the Corner Radius slider to a value greater than 2px, then back to zero, is a valid workaround.

    Thank you for your patience. I'm sorry if this has slowed you down!

  • PhilFoss's avatar
    PhilFoss
    Community Member
    2 days ago

    Good eye DeveloperIgniti​ it does default to a radius of 2px by default, even though it shows zero in the format editor, until you change it up and back down to zero. I did a screen recording so people can see the issue. Might seem like an easy fix, but there are several other blocks that have the option to change border radius so it might be a more widespread issue.